What to do if chemical running out of AMBIC Classic power unit?
If chemical is running out of the AMBIC Paint Sprayer power unit, it could be due to a loose connector nut. Locate the leak and tighten the nut. Alternatively, the pump or relief valve might be defective, so check these units and repair or replace them as necessary.
How to fix AMBIC Classic nozzle that leaks?
If the nozzle on your AMBIC Paint Sprayer doesn't shut off cleanly or leaks, it could be due to air in the pressure line. Vent the line as described under “Initial start up”. Alternatively, the control valve might be dirty or damaged, in which case you should clean or replace it.
General| Brand | AMBIC |
|---|---|
| Model | Classic |
| Category | Paint Sprayer |
| Language | English |
Provides a diagram illustrating the system's components and their connections.
Illustrates key steps and components for installing the teat spray system.
Illustrates various components and assemblies related to system maintenance.
Illustrates the correct usage and spray techniques for the teat spray system.
Lists and identifies the various parts of the teat spray system with reference numbers.
Details essential safety guidelines and warnings for using the teat spray system.
Provides detailed instructions for positioning and connecting system components.
Guides through the process of starting the system and purging air.
Explains disinfectant compatibility, spray technique, and end-of-milking procedures.
Details specific maintenance tasks for components like valves and pumps.
Lists common faults, their causes, and recommended remedies for the system.
Presents key technical data including power, consumption, and pressure.
Statements confirming the product's compliance with relevant EU directives.
Illustrates and lists available spare parts for the teat spray system.
To Next Page