13Lockit+ Users manual |
Good to Know: Plug and Play Timecode
Instead of using the graphical menu of the Lockit+ (pressing
Red & Green at once) or the web interface - feed in time-
code and frame rate externally.
Just plug the Lockit+ to the TC Out port of another device (e.g.
your Sound Recorder) and it will automatically take over time-
code and frame rate.
This only works if no Single Jam has been sent - or a C-Jam / TX
Master is active in the ACN channel. Indicated by the LED ashing
red and green alternately.
If the device is already jammed and you attach an external time-
code source, you can enter the “Compare Screen”. This displays
a potential timecode drift between external source and your
Lockit.
The built-in server spans a local WiFi, giving users browser-based
access to all the Lockit+ features via mobile device or computer.
Per default the WiFi name and password are both the serial number
of your Lockit+.
Once connected to the WiFi of your Lockit+, you can access the web
interface by entering ”10.0.0.1” or “serialnumber.local” in the address eld
of your browser (z.B. Chrome, Firefox, Safari, Edge …)
If you forgot your WiFi password, you could reset the WiFi and LAN settings
in the shutdown menu. Long-press Power, then press
Red & Green
simultaneously.
8. Access the Web Interface
To Next Page
Loading...
