Once the LS KIT 3 is wired up, follow these Calibration Steps:
10b. LS KIT 3 | L AMPLIFIER CALIBRATION
I. Use the Knob labeled “GAIN’’, and turn Counter Clockwise, all the
way down to the left, towards the number 0.
II. Connect your Bluetooth source device and turn its volume all the
way up. Play some music.
III. Slowly turn the “GAIN’’ Knob on the L300 Amp Clockwise, to the
right, toward the number 10.
As soon as you see the “CLIPPING” lights start to flicker red, turn
the knob back to the left slightly, so the clipping lights do not show.
Now this is the ideal position & should be left as is, so volume can be
controlled from the source device.
IV. After following these calibration steps, ONLY the source device
should be used to control volume during future use.
Once you’re confident that the system is working correctly, go ahead
and bury the wires. After the wires are buried, check the system once
again to make sure all the speakers and the subwoofer are connected
and working.
DO NOT ENGAGE BRIDGE MODE FOR ANY OF THE KITS
ONLY ENGAGE “LPF” ON THE SUBWOOFER AMP IN KIT
To Next Page
Loading...
