20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
7
ABOUT THIS MANUAL
Audience
This manual explains the installation and operation of the SMD17E2 Integrated Stepper Indexer/Driver/
Motors from AMCI. It is written for the engineer responsible for incorporating these products into a design as
well as the engineer or technician responsible for their actual installation.
These devices support the EtherNet/IP, Modbus TCP, and PROFINET protocols. Each unit contains a two
port Ethernet switch, which simplifies network wiring. When the EtherNet/IP protocol is used, the unit can
act as a node in a Device Level Ring (DLR). When PROFINET is enabled, the unit supports the Media
Redundancy Protocol (MRP) and can be incorporated in PROFINET installations that use a redundant ring
topology.
Applicable Units
This manual applies to all of the units in the SMD17E2 family.
Part Number Description
Trademark Notices
The AMCI logo is a trademark of Advanced Micro Controls Inc.
All other trademarks contained herein are the property of their respective holders.
Revision Record
This manual, 940-0S221, is the second revision of this manual. It fixes typographical errors and adds the
WEEE notification. It was first released January 9
th
, 2019.
Revision History
940-0S220: June 18
st
, 2018 - Initial Release
Read this chapter to learn how to navigate through this manual and familiarize
yourself with the conventions used in it. The last section of this chapter highlights
the manual’s remaining chapters and their target audience.
Model Number Description
SMD17E2-60-M12
Size 17 motor, 60 oz-in holding torque with sealed M12 connectors for an
IP50 rating.
SMD17E2-80-M12
Size 17 motor, 80 oz-in holding torque with sealed M12 connectors for an
IP50 rating.
SMD17E2-60A-M12 Same as SMD17E-60-M12 with an integrated absolute multi-turn encoder.
SMD17E2-80A-M12 Same as SMD17E-80-M12 with an integrated absolute multi-turn encoder.
SMD17E2-60E-M12 Same as SMD17E-60-M12 with an integrated incremental encoder.
SMD17E2-80E-M12 Same as SMD17E-80-M12 with an integrated incremental encoder.
SMD17E2-60-M12S
Size 17 motor, 60 oz-in holding torque with sealed M12 connectors and shaft
seal for an IP64 rating.
SMD17E2-80-M12S
Size 17 motor, 80 oz-in holding torque with sealed M12 connectors and shaft
seal for an IP64 rating.
SMD17E2-60A-M12S Same as SMD17E2-60-M12S with an integrated absolute multi-turn encoder.
SMD17E2-80A-M12S Same as SMD17E2-80-M12S with an integrated absolute multi-turn encoder.
SMD17E2-60E-M12S Same as SMD17E2-60-M12S with an integrated incremental encoder.
SMD17E2-80E-M12S Same as SMD17E2-80-M12S with an integrated incremental encoder.
To Next Page
Loading...