Page 10 of 13
Maintenance
Cleaning
Please shut off the unit and unplug from the mains before cleaning or performing any maintenance
Clean the surface
Clean the surface of machine with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline,
etc.; otherwise, the surface of the air conditioning will be damaged or even the whole machine will be
damaged.
Air filter cleaning
If the filter screen is clogged with dust, the effectiveness of the air conditioning is reduced. Please schedule
clean the filter screen once every two weeks or as often as necessarily in your environment.
A: Clean the upper filter screen frame
a: Grip the edge of the evaporator filter screen frame with both hands. Pull out to remove the filter screen
from its frame. If present, unscrew the screws fixing the filter before removing it (as shown in the above
figure) .
b: Put the evaporator filter screen into warm water with neutral detergent (about 40℃ /104℉) and dry it in
the shade after rinsing clean.
B: Clean the lower filter screen frame
a: Hold the handle of the air inlet filter screen frame, and pull it outward gently to remove it.
b: Put the filter screen into warm water with neutral detergent (about 40℃ / 104 ℉) and dry it in the shade
after rinsing clean.
End of Season Maintenance
1. Pull out the plug from the drainage hole and empty the internal tank. You can also drain the water by
leaning the unit.
2. Then switch the unit to low fan mode.
3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to keep the inside of the
unit dry and prevents mold developing
4. Turn off the unit and pull out the plug.
5. Coil the wire and bind it together, then put it into the accessories space.
6. Separate the air-exhaust pipe and store it safely.
7. Cover the unit and keep it in a dry place.
8. Take the batteries out of remote control and store or dispose, them safely
Keep all accessories with the unit ready for next season.
To Next Page
Loading...
