14
Solo
Care of Your IonCleanse
®
Unit
The array housing is made of acrylic, which will attract and hold
debris from the baths. Clean your array between sessions with a
disinfectant such as a kitchen/bathroom cleaner, grapefruit seed
extract, or vinegar. We recommend that you soak your array in
an ascorbic acid solution every 10 sessions to remove any excess
corrosion. Please see instructions on the sample bag.
The life of your plates will vary depending on the amount of chlorine
and fluoride in the water and the acidity of your clients. Because
corrosion rates vary widely across the country, we cannot guarantee
the number of sessions that you will get from a set of plates.
In order to determine if your plates need to be changed, a physical
inspection is required. Refer to Figure 2 which shows the gradual
decomposition of the plates. The last picture in the series displays a
fully used set of plates.
Fig. 2
Call us at (303) 755-0112 or visit our website at
www.amajordierence.com to order new plates and other
accessories.
0 Sessions
20 Sessions
10 Sessions
30 Sessions
To Next Page
Loading...
Need help?
General
