8
Solo
Manual Polarity Override
To manually override positive polarity output to the array, press (+)
while the unit is running; to manually override negative polarity
output to the array, press (-).
Increasing Conductivity
The conductivity of the water determines the amount of ionization
potential, which, in turn, determines the eectiveness of the session.
For our purposes, conductivity relates to the water’s ability to
transmit a small amount of current. All types of water, except
distilled water, have some degree of conductivity. Regardless of
your geographic location, the IonCleanse
®
by AMD removes all
guesswork as to the amount of salt you should add in order to
increase conductivity. If the unit shows less than 1.8 amps, add
a small amount of salt to the water in order to raise the water’s
conductivity.
Important note: Add as little salt as possible to the water in order to
maximize the life of the array. The less corrosive material in the water,
the longer the metal plates will last.
The optimum operating range of the IonCleanse
®
unit is between
11-20 volts, and 1.8-2.5 amps. Both of these readings are displayed
during an IonCleanse
®
session.
To Next Page
Loading...
Need help?
General
