23
You can determine whether your equipment is causing interference
by turning it o. If the interference stops, it was probably caused by
the equipment. If your system does cause interference to radio or
television reception, try to correct the interference by using one or
more of the following measures:
• Turn the television or radio antenna until the interference
stops.
• Move the equipment to one side or the other of the
television or radio.
• Move the equipment farther away from the television or
radio.
• Plug the equipment in to an outlet that is on a dierent
circuit from the television or radio. (That is, make certain
the equipment and the television or radio are on circuits
controlled by dierent circuit breakers or fuses.)
If necessary, contact AMD or consult an experienced radio/
television technician for additional suggestions.
Important: Changes or modifications to this product not authorized
by AMD, could void the EMC compliance and negate your authority to
operate the product. This product has demonstrated EMC compliance
under conditions that included the use of compliant peripheral devices
and shielded cables between system components. It is important that
you use compliant peripheral devices and shielded cables between
system components to reduce the possibility of causing interference to
radios, television sets, and other electronic devices.
Responsible party: AMD 7318 S Revere Pkwy, B7, Centennial, CO
80112, 303-755-0112.
To Next Page
Loading...
Need help?
General
