4.3.2.7 Video Displays Flicker During System Startup
This is normal during AMD CrossFireX startup.
4.3.2.8 AMD CrossFireX™ Disabled After Swapping/Moving Cards
If you change the AMD CrossFireX configuration by moving the graphics cards to
different slots on the motherboard, disable AMD CrossFireX and restore factory
default settings in the Control Center software application first. Once the cards have
been swapped, enable AMD CrossFireX. This ensures the new configuration is
detected by the computer.
4.3.3 HDTV/HDTV Adapter Troubleshooting
The following troubleshooting tips may help if you experience problems with HDTV.
More troubleshooting information can be found on the AMD Web site. Please visit
amd.com and select Customer Care.
4.3.3.1 The colors on the TV display are incorrect.
Ensure that the connections between the component video adapter and the HDTV are
correct.
4.3.3.2 There is no display on the TV.
The TV will not display anything until Windows starts; this may take several minutes.
Make sure the TV is set to YPbPr input.
Also, make sure that the HDTV component video adapter is properly connected.
4.3.3.3 DVDs will not play in high-quality modes.
For displays connected using an analog connection, playback of CSS-protected DVDs
may be restricted to certain modes.
For displays connected using a digital connection, playback on certain DVD players
may also be restricted if HDCP (high-bandwidth content protection) cannot be enabled.
This restriction also applies to displays connected using active DisplayPort adapters.
4.3.3.4 The entire display is not visible.
If the component input device supports it, try 720p mode.
4.3.3.5 The display appears tilted.
Consult the HDTV documentation.
4.3.3.6 The CRT display is green.
The system is in component output mode. Restart the computer with only the CRT
monitor connected.
22 Reference
AMD Radeon™ HD 6750/6770 © 2010 Advanced Micro Devices, Inc.
To Next Page
Loading...
