To Next Page

To Previous Page

Chapter 2

Hardware and Software Installation

This chapter details how to install your graphics card in your system as well as where

to download associated software and drivers.

2.1 Installation Overview

Once you have determined that your system meets the minimum requirements,

perform the following tasks to install your new graphics card. Detailed installation

instructions are provided in the following sections.

1. If you are replacing an existing graphics card, uninstall the old graphics driver

and software.

Note: If you are using a motherboard containing an on-board graphics solution

and do not intend to use it as part of a multiple monitor configuration, disable

it.

2. Turn off and disconnect your computer system.

3. If needed, remove any old graphics card(s).

4. Install the new graphic card.

5. Reassemble and connect your computer system and display(s).

6. Start the computer system and install the new AMD drivers and configuration

software.

7. Restart the computer system.

2.2 Installing the Graphics Card

1. Turn off the computer, monitor(s), and other peripheral devices.

2. Unplug the computer's power cord, and then disconnect all cables from the back

of the computer.

Caution:

Wait approximately 20 seconds after unplugging the power cord before

disconnecting a peripheral cable or removing a component from the

motherboard to avoid possible damage to the motherboard.

3. Remove the cover to the computer's case.

Note: If necessary, consult the computer manual for help in removing the

cover.

2016 Advanced Micro Devices, Inc. AMD Radeon™ R9 380 Series Graphics

Questions and Answers:

Need help?

Do you have a question about the AMD Radeon R9 380 Series and is the answer not in the manual?

AMD Radeon R9 380 Series Specifications

General