AMD Confidential
User Manual November 21
st
, 2008
Chapter 11: Debug Interface 157
Run the following automation command:
1 simnow> shell.gdb <ENTER>
Start gdb
gdb> set architecture i386:x86-64 <ENTER>
gdb> target remote:2222 <ENTER>
11.2.2 Alternate Approach
This assumes you are running the simualtor and gdb on the same machine.
Start the simulator
Run the following automation command:
1 simnow> shell.gdb <ENTER>
Add the following to your .gdbinit file
define simnow
set architecture i386:x86-64
target remote:2222
end
Start gdb
gdb> simnow <ENTER>
11.2.3 Using Another Port on the Same Machine
The simualtor defaults to using port 2222 but can be directed to use another port.
Start the simulator
Run the following automation command:
1 simnow> shell.gdb 2233 <ENTER>
Start gdb
gdb> set architecture i386:x86-64 <ENTER>
gdb> target remote:2233 <ENTER>
11.2.4 Using Two Separate Machines
Start the simualtor on simnow-host
Run the following automation command:
1 simnow> shell.gdb <ENTER>
Start gdb on gdb-host
gdb> set architecture i386:x86-64 <ENTER>
gdb> target remote simnow-host:2222 <ENTER>
11.3 Linux Host Serial Port Communication
When running the simulator on a Linux host, the serial port is able to communicate with
external host applications via either a named-pipe or the host serial port. If the user has
configuired named-pipe communication, the simualtor will set up an input pipe and an
To Next Page
Loading...