AMD SimNow Simulator 4.4.5 - AMD-8111 Device; Dbc; Generation Northbridge

AMD Confidential
User Manual November 21
st
, 2008
238 Appendix A
DMALogStatus
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
A.7.12 8
th
Generation Northbridge
1 simnow> sledgenb.usage
Automation Command
Description
LogHT (0|1)
Enables (1) or disables (0) logging.
HTLogStatus
Returns „enabled‟ if logging is enabled otherwise it
returns „disabled‟.
LogPCIConfig (0|1)
Enables (1) or disables (0) PCI Config logging.
PCILogStatus
Returns „enabled‟ if PCI Config logging is enabled
otherwise it returns „disabled‟.
GetConfig
Displays Northbridge logging configuration.
ProductFile <FileName>
Loads the specified product file “FileName”.
A.7.13 DBC
1 simnow> dbc.usage
Automation Command
Description
GetParam
Returns disk block cache parameters (size, depth and
bits).
SetParam <size> <depth> <bits>
Sets disk block cache parameters.
A.7.14 AMD-8111™ Device
1 simnow> 8111.usage
Automation Command
Description
BaseID (00|01)
This specifies the HyperTransport™ protocol base unit
ID. The IC's logic uses this value to determine the unit
IDs for HyperTransport request and response packets.
The Base ID must be 00 or 01.
GetBaseID
Returns the HyperTransport base unit ID (BUID).
HtInterrupts (0|1)
Enables (1) or disables (0) HyperTransport interrupts.
HtIntStatus
Returns „enabled‟ if HyperTransport interrupts are
enabled; otherwise it returns „disabled‟.
IoLog (0|1)
Enables (1) or disables (0) IO logging.
IoLogStatus
Returns „enabled‟ if IO Logging is enabled; otherwise it
returns „disabled‟.
MemLog (0|1)
Enables (1) or disables (0) IO logging.
MemLogStatus
Returns „enabled‟ if Memory Logging is enabled;
otherwise it returns „disabled‟.
SmiSciLog (0|1)
Enables (1) or disables (0) IO logging.
SmiSciLogStatus
Returns „enabled‟ if SMI SCI Logging is enabled;
otherwise it returns „disabled‟.