6 ENGLISH
Operating the Pump
s#ENTERNIPPLESINBREAST
mANGESANDlLLBREAST
mANGESWITHTHEBREASTS
to create an air seal.
s4URNTHEPUMP/.BYTURNING
the ‘VACUUM’ dial to the
right.
Setting Suction
sIncrease the suction by
turning the ‘VACUUM’ dial to
the right. Increase suction
until reaching maximum
comfort level.
s
)FDISCOMFORTISFELTINNIPPLES
ORBREASTSDECREASESUCTION
If discomfort is felt at all
suction settings, turn pump
OFFINSERTAlNGERBETWEENBREASTSANDBREASTmANGES
to break suction, remove BREASTmANGESFROMBREASTS.
Discontinue pumping and contact a healthcare provider.
Setting Speed
s3TARTWITHTHE@#9#,%3DIAL
all the way to the right to
increase the speed and
trigger a milk ejection reflex
LETDOWN
s7HENMILKmOWSLETDOWN
turn the ‘CYCLES’ dial to the
left to slow down the speed
to help drain the breast
faster. When milk flow slows, turn the ‘CYCLES’ dial all the
WAYTOTHERIGHTTOHELPSTARTANOTHERLETDOWN2EPEATAS
milk flow changes to pump more milk.
Turning Pump OFF
s7HENlNISHEDPUMPINGTURN
the ‘VACUUM’ dial all the
way to the left to turn the
pump off.
Removing Ameda HygieniKit Milk Collection System
from Breast(s)
s!FTERPUMPISSWITCHEDOFFIFNECESSARYINSERTAlNGER
BETWEENBREASTSANDBREASTmANGESTOBREAKSUCTION
s2EMOVEBREASTmANGESFROMBREASTS
Set Up and Assembly
Ameda HygieniKit Milk Collection System
Before Every Use
Always wash hands well with soap and water before
handling the Ameda Elite Breast Pump and Ameda
HygieniKit Milk Collection System.
IMPORTANT NOTE: ONLY USE THE AMEDA HYGIENIKIT
MILK COLLECTION SYSTEM ON AMEDA ELECTRIC BREAST
PUMPS.
Prior to starting pump, assemble and connect the Ameda
HygieniKit Milk Collection System, per included instructions.
If the Ameda HygieniKit Milk Collection System is sterile, use
as is. If not sterile, see the Ameda HygieniKit Milk Collection
System cleaning instructions.
Tubing
Silicone Diaphragm
Adapter Cap
Milk Bottle
Valve
Breast Flange
Tubing Adapter
The Ameda HygieniKit Milk Collection System can be used
to single or dual pump.
To dual pump:
Both tubes should be
attached to tubing
adapter.
To single pump:
Remove one tube and
close tubing adapter.
s)NSERTTUBINGADAPTERINTO
tubing adapter port on
piston/cylinder.
1
2
3
4
5
Elite with Detachable Power
Cord
s!TTACH!MEDASUPPLIED
power cord to AC power
inlet on rear of pump.
s#ONNECTPOWERCORDTOWALL
outlet.
Elite with Built-in Power
Cord
s#ONNECTPOWERCORDTOWALL
outlet.