Quick SetUp
Simply take your StoryPhones out of the box
and press the play button for 2 seconds! Your
StoryPhones are ready to play.
Now, set up your system...
(more details on pages 3 & 4)
Install the software by inserting the CD
into the CD drive of your PC and the
software will run. For more information
please see page 3.
Plug the Base Unit into the mains power
supply using the power supply unit.
Connect the Base Unit to the PC with the
USB cable.
Put the Headsets and Remote Console into
the Base Unit one at a time and wait for
each one to appear in Bookshelf before
adding the next player. (It may take a short
time for each player to appear as software
drivers are installed).
Your system is ready to use.
1
2
3
4
To Next Page
Loading...