GUIDE FOR PASSAGE THROUGH A 30” OPENING
1. Open the blanket frame to its natural stopping point. Then push the blanket frame
further upward, at which time the glass frame will rise. Grab hold of the glass frame and
continue to open it to full extension.
2. To separate the unit into two sections, reach down into the right front corner of the unit,
and disconnect the electrical connector and the vacuum hose. For MODELS 335 &
340, remove the 4 corner screws holding the two sections together (use a 5/16” nut driver
or standard screw driver).
3. Close and latch the blanket frame before removing the sections from the pallet. Have
enough individuals assist in the removal of each section by firmly supporting each
corner. Do not lift the top section by the blanket frame.
4. Move both sections through the opening sideways, taking care to prevent movement of
the blanket frame.
5. Reposition the sections in the set up area and open the blanket and glass frames. Reach
down into the right corner and connect the electrical connector and the vacuum hose
fitting. For the MODELS 335 & 340, re-insert and tighten the 5/16” screws.
6. Follow the appropriate Set Up instructions found three pages previous.
To Next Page
Loading...