SENSORRAIL IIIE 8200-0593-03, REV. A
SERVICE GUIDE
23 of 34
Copper Install Tool ADRLCIT
This tool is used to install new copper strips and also reverse old copper strips due to green patina from
previous collectors that ran over it. The latest tool is turned using a wheel instead of handles.
To wind the existing copper back
on to the wheel, rotate the wheel
in the direction of the arrow shown
above.
To unwind the copper back into
the rail, flip the support bars 180°
and rest the wheel in the slot as
shown. Use the service trolley to
pull the strips.
To Next Page
Loading...
