P
age 7 of 11
AE-1220 / AE-3050 /
AE-4065 / AE-5080
Operation Manual
773.376.0800 (P) • 773.376.2010 (F) • 3131 S. Canal St. Chicago, IL 60616
Revision 1/2017
Cleaning Procedures
SPIRAL MIXER CLEANING & SANITIZING:
1. Make sure the unit is turned off and disconnected from the power outlet.
2. After each day’s use, wash the mixer bowl and agitator thoroughly with hot water and a mild
soap solution and rinse with either a mild soda or vinegar solution.
3. Rinse thoroughly with clear water and wipe dry with a soft clean cloth.
4. Wipe exterior of machine with a clean damp cloth.
5. Clean under machine occasionally: disconnect power cord, raise stabilizing feet, and move
machine.
ELECTRICAL CONNECTIONS:
WARNING: BEFORE CONNECTING YOUR MACHINE
TO ANY SOURCE OF ELECTRICAL POWER, READ THE
SPECIFICATIONS ON THE MACHINE’S NAMEPLATE
CAREFULLY. BE SURE THEY COINCIDE WITH THOSE
OF YOUR POWER SOURCE.
• Electrical connection should be carried out by a qualified
person and should comply with all relevant safety rules and regulations.
• Appropriate fuses must be installed to provide adequate protection in case of a short circuit.
• Special attention should be given for 3 Phase power to making the correct electrical
connection regarding the direction of rotation of the spiral agitators. The correct direction of
agitator rotation is indicated by an arrow on the front of the mixer.
NOTE: INCORRECT INSTALLATION AND WIRING WILL VOID WARRANTY. PLEASE ENSURE AFTER
WIRING THAT THE AGITATOR IS ROTATING IN THE CORRECT DIRECTION. RE-WIRE THE POWER
PLUG IF THE AGITATOR IS ROTATING IN THE WRONG DIRECTION.
To Next Page
Loading...