American Panel Walk-in Monitoring System 200 - Battery Charge Settings; Real Time Clock Setup

PROGRAMMING
8
The display will show:
Battery Charge
Press
or to set the flashing value to “Y” (Yes) to enable the
battery charging feature.
Press
when done.
Next, WIMS 200 will check the battery and display the message on the right for a
few seconds.
Once the controller detects the batteries, it will prompt you for the time settings.
Note: If the battery charge function is disabled, the “Batt.” message will not be displayed.
The display will show:
Real Time Clock Settings
Press or to set the flashing value to “Y” (Yes) if you wish to
enable the real time clock. If real time clock is enabled, the time will be displayed
during normal operation.
Press when done.
The display will show:
Press
or to change the flashing value to current year.
Press when done.
The display will show:
Press or to change the flashing value to current month.
Press when done.