6.
While pushing forward, slide the detector down until
a clicking sound is heard. The detector should now be
secured in place.
.
1
7.
Tutn
the power back on at the fLse box or service panel.
8. Your Detector should be sewiced by Qualified Service
Personnel only. AC power should always be turned off
before servicing the detector. To remove the detector
from its mounting plate, the locking mechanism (located
in the top-right corner) must be released as you slide the
detector unit upwards. This will expose your electrical
wiring and should be approached with extreme caution,,
Kit includes:
-
Plastic round mounting plate -
1
pc.
- Plastic box mounting plate - lpc.
- Marrette twist-on wire connectors - 2 PCS.
- 5/8 inch square head screws - 2 PCS.
15
SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com
To Next Page
Loading...