How can you Test/Reset the detector?
’ A green power light indicates that power is supplied.
To test the detector (wait at least ten minutes after
installing it), press and release the
Test/Reset button.
The detector will beep and a red light will flash.
rrgl
Test/Reset
button
To reset after an alarm
or a low level warning,
press the
-T~st/IWet%~tto~ to silence or reset the-unit. Follow.
the instructions on pages 20 and
21
or
pages 22 and 23,
which tell you what to do after an alarm or low level
warning. The American Sensors Carbon Monoxide
Detector is designed to do a continuous self-diagnostic
check of its micro processing circuitry when in use.
A malfunctioning unit is indicated by a continuing
intermittent single beep and flashing green/red light.
If this occurs, reset the unit. If the unit again beeps
intermittently, do not use this unit. Do not confuse
this single beep sound with the low level carbon
monoxide warning -
a series of 3 short beeps and
3
fltihes of th
e red light every 2.5 minutes. If you have
any questions regarding your detector, please call our
Healthy Home Hotline at:
American Sensors 1-800-387-4219
(Help is available 24 hours every day including holidays.)
16
SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com
To Next Page
Loading...