To Next PageTo Next Page
Need help?Do you have a question about the American Standard 4A6V8036A1000A and is the answer not in the manual?
Critical safety precautions for installation and servicing of HVAC equipment, including general warnings.
Dangers of electrical shock, emphasis on disconnecting power before servicing.
Information on R-410A refrigerant, oil requirements, and system sealing.
Cautions regarding refrigerant under pressure and proper recovery procedures.
Importance of proper grounding for electrical safety and equipment protection.
Cautionary advice for operating service valves to prevent refrigerant release.
Warning about high leakage current and the necessity of earth connection.
Warning about a 400VDC electrical hazard, requiring wait time and voltage verification before servicing.
Steps for evacuating the system to a specific micron level using a vacuum pump.
Worksheet and steps for calculating refrigerant charge for new systems using the weigh-in method.
Worksheet and steps for calculating refrigerant charge during sealed-system repairs using weigh-in.
Guidelines for high voltage power supply, nameplate agreement, and compliance with codes.
Instructions for installing a disconnect switch and grounding the outdoor unit.
Instructions for setting the thermostat, waiting periods, and using the 'Charging Mode-Cooling' test.
Comprehensive checklist for verifying wiring, voltage, refrigerant lines, brazing, ductwork, and system operation.
General| Type | Split System Air Conditioner |
|---|---|
| Model Number | 4A6V8036A1000A |
| Brand | American Standard |
| SEER Rating | 16 |
| SEER | 16 |
| Refrigerant | R-410A |
| Voltage | 208/230 |
| Phase | 1 |
| Hertz | 60 |
| Stages | Single-stage |
| Sound Level | 72 dB |
| Sound Level (Outdoor Unit) | 72 dB |
| Cooling Capacity | 36000 BTU |
| Compressor Type | Single Stage |
