NOTE: Pictures may not exactly depict toilet seat and components.
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly,
please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your
installation conforms to local codes.
TOILET SEAT
INSTALLATION INSTRUCTIONS
7302106-100 Rev. C 2/15
All product names listed herein are trademarks of AS America, Inc. unless otherwise noted.
© AS America, Inc. 2015
SAVE FOR FUTURE USE
3
2
4 5
Side view of the toilet seat installation parts.
The hinge cap covers are designed to snap
lock on to the hinge. Position the hinge
covers and push down on the cover.
With the plastic bolts installed, thread the
winged plastic nuts on to the bolts.
When the seat is properly aligned with the
front edge of the bowl shlip the bolt through
the washer and the bowl bolt holes.
6
Tighten the bolts using a screwdriver.
Hinge
Cover
Hinge
Plastic
Bolt
Plastic
Wing Nut
Under Hinge
Base
Hinge
Gasket
Slot
Alignment
Tab
Hinge
Gasket
Adjustment
Washer
1
Attach Hinge Gaskets to bottom of Hinge Base.
Make sure Alignment Tabs on Hinge Gaskets
match the slots under the Hinge Base.
The installation kit includes two sets of stainless washers:
2 with center holes and 2 with offset holes. The offset
washers hole can be set forward or back allowing the
seat to be moved back from or to the forward edge of
the bowl rim.
Align hinges over holes on toilet bowl.
FRONT OF BOWL
TANK
To Move
Seat Forward
To Move
Seat Back
BOTTOM MOUNT
To Next Page
Need help?
General
