To Next PageTo Next Page
Need help?Do you have a question about the Ameristar M4AH3030B1000AA and is the answer not in the manual?
Guidelines for installing refrigerant lines, including bending, insulation, and noise isolation.
Details on using correct brazing materials and procedures for R410A systems, including nitrogen purging.
Procedure for connecting liquid and suction lines, including brazing and leak testing.
Detailed steps for evacuating the system to 350 microns or less and leak detection methods.
Electrical supply checks, grounding requirements, and conductor material specifications.
Steps for installing disconnect switches, running power wiring, and making connections.
Instructions for checking the system's refrigerant charge, emphasizing not operating without charge.
Detailed steps for charging the system using liquid pressure based on outdoor ambient temperature.
Procedure for adjusting refrigerant charge by weight, calculating required charge based on line set.
Using a halogen leak detector to check all piping connections for leaks after charging.
Schematic showing high and low voltage wiring connections for the outdoor unit.
Diagram illustrating control wiring connections between the thermostat, indoor, and outdoor units.
Step-by-step guide for replacing the fixed orifice or installing a TXV.
Table correlating system faults with primary and secondary causes for diagnosis.
Checklist for final unit operation verification and checkout after installation.
General| Model | M4AH3030B1000AA |
|---|---|
| Type | Air Conditioner |
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Phase | 1 |
| Compressor Type | Scroll |
| Tonnage | 2.5 Ton |
| Cooling Capacity | 30000 BTU/h |
