–9–
Optional Long Range Radio
• Allows all messages that have been programmed to go to the primary
telephone number to be reported additionally to a 7720PLUS or 7820
radio. Check availability of these models.
Built-in Telephone Line Monitoring Option
•The telephone line voltage can be monitored to supervise the phone line
connection. The panel must be connected to a proper earth
ground or you will get a false line cut indication if this feature
is enabled.
• The loss of the line can optionally cause a local display, or a display and
trouble sound.
Event Logging
• Event Logging feature keeps a record of selected events in a history log
(up to 48 events). All control and readout from the log is done via
Ademco V-Link software only.
Alarm Output
• Provides a 12VDC, 2 AMP output that can drive the compatible
sounders listed in the EXTERNAL SOUNDERS section (assumes a fully
charged battery is connected)
.
• Steady output for Burglary/Panic, or temporal pulse output (3 pulses –
pause – 3 pulses – pause – 3 pulses. . .) for Fire.
• Uses current limiting circuitry for protection.
Auxiliary Power Output
• Provides 12VDC, 600 mA maximum. Uses current limiting circuitry for
protection.
• This output interrupts for smoke detector reset if 4-wire smoke
detectors are used.
Programming
• Programmed options are stored in electrically erasable, non-volatile
EEPROM memory (information can be reprogrammed at any time and
will not be lost in the event of a power loss).
• The system can be uploaded, downloaded, or controlled via an IBM
compatible computer, V-Link software and a HAYES modem specified
by Ademco.
Keypad programming consists of:
• Data field programming
• Interactive (menu) mode programming
Communication Formats Supported
• Ademco Low Speed (Standard or Expanded)
• Sescoa/Radionics (Standard or Expanded)
• Ademco Express
• Ademco Contact ID
Zone Descriptors
You can assign Alpha descriptors to all zones (useful only when using
Alpha keypads and/or the 4285/4286 Phone Module).
AC Power Supply
Uses 1321, 110VAC plug-in transformer with 16.5VAC 25VA output,
unless Powerline Carrier devices (ex. X-10 type) are used, in which case a
4300 transformer module must be used.
Back-Up Battery
• Rechargeable (Gel type) 12VDC, 4AH minimum.
To Next Page
Loading...