–94–
AM6139
REMOTE KEYPAD
1. Physical: 6-1/4" W x 4-3/4" H x 1" D (159mm x 121mm x 26mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 100mA
3. Interface Wiring: Same as AM6128.
5881/5882 SERIES
RF RECEIVERS
(5800 System)
1. Physical: 7-3/8" (188mm) W x 4-3/8" (112mm) H x 1-7/16" (37mm) D
Note: 10-7/8" (277mm) H with antenna
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA
3. Interface Wiring: Same as AM6128..
4. Range: 200ft (60m) nominal indoors from wireless transmitters (the
actual range to be determined with system in TEST mode).
5. Zones: (With the AM100)
5881L/5882L: accepts up to 8 transmitters
5881M/5882M: accepts up to 16 transmitters
5881H/5882H: accepts up to 30 transmitters
5800TM
TRANSMITTER
MODULE
used with 5827BD
Wireless 2-Way Keypad
1. Physical: 2-1/4" W x 4-1/8" H x 7/8" D (57mm x 105mm x 22mm)
2. Electrical: Voltage Input: 12VDC Current Drain: 20mA
3. Interface Wiring: Same as AM6128..
4219
WIRED EXPANSION
MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA
3. Interface Wiring: Same as AM6128..
4. 8 EOLR Loops (A–H): Loop A can be set for fast (10–15msec)
response to an open.
4204
RELAY MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 15mA(Relays off)
180mA (Relays on)
3. Interface Wiring: Same as 6127
4. Four Output Relays: SPDT Contacts,
Rating: 2A max at 28VDC/AC
4229
WIRED EXPANSION/
RELAY MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA (Relays off)
100mA (Relays on)
3. Interface Wiring: Same as AM6128..
4. 8 EOLR Loops (A–H): Loop A can be set for fast (10–15msec)
response to an open.
5. Two Output Relays: SPDT Contacts, Rating: 2A max at 28VDC/AC
4285/4286
PHONE MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC Current Drain:160mA
3. Device Address: Permanently set to address 4.
4. Interface Wiring: See 4285/4286 PHONE MODULE section on pages 32
thru 35 inclusive.
5. Telephone Line Connections: See 4285/4286 PHONE MODULE section
on pages 32 thru 35 inclusive.
4286VIP
PHONE MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC Current Drain:300mA
3. Device Address: Permanently set to address 4.
4. Interface Wiring: See 4286VIP PHONE MODULE section on pages 32
thru 35 inclusive.
5. Telephone Line Connections: See 4285/4286 PHONE MODULE section
on pages 32 thru 35 inclusive.
To Next Page
Loading...