AMERITRON AL-1200 - UNPACKING INSTRUCTIONS

UNPACKING INSTRUCTIONS
1. Carefully remove the amplifier, transformer, and tube from their shipping cartons.
Inspect each item for visible damage. If any damage occurred during shipment,
notif
y
the trans
p
ortation com
p
an
y
immediatel
y
.
2. Save all packing materials in case you need to return your AL-1200(X) for factory
service. The cartons have been designed to give maximum protection for this
amplifier. Any units returned without proper packing may be damaged and
shipping claims cannot be made. Contact the factory before returning any units.
3. Remove the screws that hold the cover to the amplifier. Slide the cover back and
remove it from the amplifier. Remove the package that is in the area where the
transformer will be mounted. This package contains the chimney for the
3CX1200A7. There is also a small package that contains the fuses, fuse caps and
the remainder of the chassis screws.
4. Please read the GENERAL INFORMATION and SPECIFICATIONS sections
before attempting to install the transformer and tube. Go to the INSTALLATION -
section on page 4 to begin installing the transformer and tube.
5. This amplifier must always be disconnected from the power mains before removing
the cover. See the precaution on page 10. Please read the entire manual to become
familiar with the o
p
eration of the AL-1200
(
X
)
am
p
lifier.