11
A01-00104 Rev A
FCC ISSUES
Attention
This UPM has been tested and found to comply with the limits for a Class A
digital devices (Class B compliance optional), pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against
harmful interference in both residential and commercial environments.
This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio and/or television reception, which
can be determined by turning the UPM equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Relocate the UPM
Relocate the load.
This device complies to Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept interference received, including interference
that may cause undesired operation.
To Next Page
Loading...
Need help?
General
