Ametek JOFRA ATC-125 A - Page 101

105446 06 23-03-2009 101
THERMAL SPECIFICATIONS ATC-156 A/B
Well specifications 40 mm ( 1.57 inch) axial homogeneity :
0.05°C (0.09°F) @155°C (311°F)
0.05°C ( 0.09°F) @100°C (212°F)
0.05°C ( 0.09°F) @0°C (32°F)
0.05°C ( 0.09°F) @-24°C (-11.2°F)
50 mm (1.97 inch) axial homogeneity:
0.07°C (0.13°F) @155°C (311°F)
0.05°C (0.09°F) @100°C (212°F)
0.06°C (0.11°F) @0°C (32°F)
0.09°C (0.16°F) @-24°C (-11.2°F)
60 mm (2.36 inch) axial homogeneity:
0.10°C (0.18°F) @155°C (311°F)
0.06°C (0.11°F) @100°C (212°F)
0.08°C (0.14°F) @0°C (32°F)
0.12°C (0.22°F) @-24°C (-11.2°F)
70 mm (2.76 inch) axial homogeneity:
0.13°C (0.23°F) @155°C (311°F)
0.08°C (0.14°F) @100°C (212°F)
0.10°C (0.18°F) @0°C (32°F)
0.16°C (0.29°F) @-24°C (-11.2°F)
80 mm (3.15 inch) axial homogeneity:
0.18°C (0.32°F) @155°C (311°F)
0.11°C (0.20°F) @100°C (212°F)
0.11°C (0.20°F) @0°C (32°F)
0.25°C (0.45°F) @-24°C (-11.2°F)
Difference between borings :
0.01°C (0.02°F)
Influence from load :
0.10°C (0.18°F) @155°C (311°F)
0.10°C (0.18°F) @-24°C (-11.2°F)