AMETEK CTS NSG 4070
Quick Start and Safety Guide 16 / 20
5 Remote
Connect the NSG 4070 with a suitable mains socket.
Switch the unit on.
Connect the NSG 4070 and USO 4013 to the PC.
Press “Setup“.
Press “Remote“.
Press “RS232 optical“.
Press “Back“
Press “Baudrate setup“
Change the settings as required. (Default value is 11500 Baud)
Connect the NSG 4070, USO 4013 and PC as shown in the figure.
The device manager under Windows 10 shows the USO 4013 after successful driver installa-
tion. The port number, in the example COM 4, must be entered in the application software.
To Next Page
Loading...
