EasyManua.ls Logo

Ametek Reichert Tono-Vera Vet - Data Transfer; Connecting Tono-Vera Vet to the PC; Transferring Data to the PC

Ametek Reichert Tono-Vera Vet
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16308-101 Rev. A • 19
Instructions for Use (continued)
Data Transfer
Tono-Vera Vet is capable of transmitting data via Bluetooth® to EMR,
using ReichertSync
Software. To successfully transmit data, Tono-
Vera Vet must be paired with a PC that has ReichertSync installed on
it. To obtain a copy of ReichertSync, contact the Reichert Technical
Support Group at the contact information at the back of this manual.
Install ReichertSync on your PC. Refer to the ReichertSync
Instructions for Use to set up Tono-Vera Vet in ReichertSync.
Navigate to the Bluetooth screen in the Menu.
Follow the directions in ReichertSync to pair Tono-Vera Vet and
the PC. When Bluetooth is enabled, a Bluetooth icon will appear
in the upper right corner beneath the Battery Indicator. This
indicates the status of the Bluetooth connection.
After obtaining Final IOP Results, press the center Multifunction
Button to transfer data to the PC. A countdown may appear
indicating that data is transferring.
Once the data has been transferred, a Bluetooth icon in a green ring
will briefly appear on the screen. The IOP measurements will clear
out and the device will be ready to take a new measurement.
NOTE: If an error occurs, the Bluetooth symbol will appear in an
orange ring. Refer to the Troubleshooting section of this manual.
NOTE: After Tono-Vera Vet is paired to the PC, the Bluetooth
connection will automatically reconnect when the device is powered
up. If Tono-Vera Vet does not automatically reconnect to the PC, refer
to the Troubleshooting section of this manual.
To disable Bluetooth, navigate to the Bluetooth screen in the Menu
and press the Select Button. The large Bluetooth icon will turn gray
and the small Bluetooth icon in the upper right will disappear.
1
1
2
3
4
5
Press the Select Button to enable
Bluetooth. The Bluetooth icon will
turn white when Bluetooth is enabled.
1
2
Connecting Tono-Vera Vet to the PC
Transferring Data to the PC
No Dots:
Not Connected
Green Dots:
Connected and Able to
Transfer Data
TonoVera-28461
14.5 14.5