Unit power / Measure button - Connected mode
Power
• Both the display unit and the traverse unit can be switched on in
Connected mode configuration when the only the display unit
power button is pressed. However, to power OFF, both traverse
and display unit will need to be powered off individually. Hold the
red power button for 3 seconds or more to switch OFF / ON.
Measure
• Press the red button on the display unit for < 3 seconds
Device icons
Page down
Connectivity
status
Settings
Calibration
menu
Measurement
results
Measurement
profile graph
Page tabs
Battery level /
Charging indication
To Next Page
Loading...
