Keeping it simple
The Surtronic philosophy keeps the process simple. It is the perfect
tool for any inspector to check surface roughness even in the most
demanding applications.
• Incoming inspections
• Final inspection before shipment
• Process control on the production line
• Checking large components or structures
Standards and traceability
The reference standard supplied can be used both to calibrate the
instrument and check for stylus wear to ensure the most accurate
results are always being achieved.
UKAS calibration and testing
Taylor Hobson provides full certification for artefacts and instruments
in our purpose built ISO graded clean room UKAS facility. Our
UKAS laboratory is able to measure all of the parameters associated
with surface texture, including French, German, USA and Japanese
derivatives.
Measurement Best capability
Roughness standards (Ra) ±(2% + 0.004 µm)
Workpiece or component
surface texture (Ra)
±3% of measured value per
trace
To Next Page
Loading...
Need help?
General
