Need help?Do you have a question about the Ametek T and is the answer not in the manual?
General| Brand | Ametek |
|---|---|
| Model | T |
| Category | Water Pump |
| Language | English |
Details the different T-series pump models (T-1, T-1-CPF, T-1/VITON, etc.) and their specifications for pressure medium and O-rings.
Lists various T-3 pump models for hydraulic comparator kits, categorized by gauge pressure ranges and O-ring materials.
Contains critical safety information, including warnings against external pressure sources and operating limits, and cautions for fluid handling.
Provides step-by-step instructions for assembling the Type T Series hand pump, starting with opening the vent valve.
Explains how to generate pressure using the Type T Series pump, including setting the valve rod and operating the pump handle.
Provides a detailed procedure for priming the pump, addressing loss of prime due to entrapped air in the reservoir.
Illustrates various Crystal Reference Indicators and their associated fittings, showing connection types like NPT, CPF, and BSP.
Addresses common problems encountered with the pump, starting with 'Failure to Pump'.
Provides a step-by-step procedure for replacing the O-rings on the high pressure and low pressure check valves.
Diagnoses and provides a solution for pumps that lose pressure, identifying leaking O-rings as a common cause.
Details the procedure for replacing the O-ring on the discharge check valve, involving removing the retaining plug and valve components.
Explains how to replace the O-ring for the vent valve and relief valve seat, involving removal and reinstallation of parts.
To Next Page
