Ametek TAYLOR HOBSON TALYROND 500 PRO - Table of Contents

3
English
Contents
Introduction ................................................................................. 4
Start up procedure ..................................................................... 4
Metrology 4.0 software .............................................................6
User interface .......................................................................................................7
Selecting the stylus .........................................................................................19
Calibration ..................................................................................21
Calibrate to scale and crutch angle ......................................................21
Flick standard .....................................................................................................22
Slip blocks ............................................................................................................24
Ball calibration (for contour measurement) ....................................26
3-line standard ..................................................................................................28
Calibration procedure (Ball) - good and bad results .................31
Calibration artefacts ......................................................................................32
Measurement .............................................................................34
Making a Roundness measurement......................................................34
Making a 2D Z / 2D X measurement ................................................35
Making a Cylinder Map measurement ................................................36
Making an Ultra High Precision Roundness (UHPR)
measurement ....................................................................................................37
Measurement settings ..................................................................................39