Ametek VersaSTAT LC Series - Figure 2. LCI-Potentiostat Interface Cable; LCI Interface Cable; LCI Main Body; Table 1. Low Current Interface

VersaSTAT LC Low Current Interface (LCI) Hardware Manual P/N 224186_0B
2
Table 1. Low Current Interface
PAR Potentiostat/Galvanostat Models that
Support the VersaSTAT LC Low Current Interface
VersaSTAT 3
VersaSTAT 4
VersaSTAT 3F
VersaSTAT MC
PARSTAT 4000
PARSTAT MC
The LCI consists of:
1) Interface cable that connects the cell cable interface of the potentiostat/galvanostat to the LCI main
body.
2) LCI main body.
3) Four (4) coaxial cell leads that connect from the LCI main body to the electrodes and/or cell
under test, as well as a ground lead.
1.2.1. LCI Interface Cable
The LCI-potentiostat interface cable (part number 223763, shown below) is a 1m long cable designed
specifically for the LCI. The cable is bi-directional, meaning that both ends are identical and may be
connected to either the LCI or potentiostat interfaces.
Figure 2. LCI-Potentiostat Interface Cable
CAUTION This cable is not to be modified from its original configuration.
1.2.2. LCI Main Body
The main body of the LCI is 19cm X 15cm X 4.5cm assembled. The cell cable panel (shown below-left)