MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION VI - PROGRAMMING
6.6 PROGRAM SELECT FUNCTION
2. Press the F key under WELD SELECT and the screen will then ask what
WELD # should be in position 1. Then position 2, 3 and 4. You do not have
to select all 4, just the ones you want selectable from the RP . When all
choices (up to 4) are made go back to the STATUS screen.
3. The M-227-RP will now be able to select one of the WELD #’s entered by use
of the Special Function Key, SELECT function.
6.7
To Next Page
Loading...
