14
OPERATION
4.Setting cook time and end time (delay
mode)
When the symbol (Cook Time) is shown,
press the
button repeatedly until the
symbol(EndTime)ashes.Currenttime
is displayed. Set End Time using the control
knob.
3.Setting cook time
Press the
button until symbol (Cook
Time)isashing(itisonlypossiblewhenthe
function selector knob is set to a position
otherthan“0”).
“00:00”willbe displayedinstead of current
time. Set cooking time using the control knob
. Time will be set if setting is not changed
within 5 seconds and the menu button is not
pressed
.
Cook time countdown begins and symbol
is on.
An acoustic signal is sounded after the set
time has elapsed (4 beeps - a pause - 4
beeps).
The sequence of acoustic signals is repeated
forapproximatelyoneminuteinthreesecond
intervals. “00:00” is displayed and the
symbol(cooktime)isashing.
To deactivate the alarm press any button
or turn oven function selector knob to “0”
or operate the control knob. Once alarm is
deactivated, current time and the selected
function are displayed, the symbol (cook
time) is off.
End Time will be set if setting is not changed
within 5 seconds and the menu button
is not pressed. End Time symbol is dis-
played.
When then delay time has elapsed, the
electronic programmer switches to mode
(Cook Time). Cook Time countdown begins,
symbol (End Time) is off and symbol
(Cook Time) is on.
An acoustic signal is sounded after the set
time has elapsed (4 beeps - a pause - 4
beeps). The sequence of acoustic signals
isrepeatedforapproximatelyoneminutein
threesecondintervals.“00:00”isdisplayed
and the symbol(cooktime)isashing.
To deactivate the alarm press any button
or turn oven function selector knob to “0”
or operate the control knob. Once alarm is
deactivated, current time and the selected
function are displayed, the symbol (cook
time) is off.
In order to erase Cook Time, End Time or
Kitchen Timer settings, press and hold
buttons for approximately 3
seconds and all settings will be erased.
Erasing the settings is only possible
when one of the electronic programmer’s
settings (Cook Time, End Time, Kitchen
Timer) was previously set.
To Next Page
Loading...
Need help?
General