29
Replacing halogen lighting in the oven
Before replacing the halogen bulb, make
sure the appliance is disconnected from
electric mains to avoid possible electric
shock.
CLEANING AND MAINTENANCE
By ensuring proper cleaning and mainte-
nance of your cooker you can have a sig-
nicantinuenceonthecontinuingfault-free
operation of your appliance.
Before you start cleaning, the cooker must
be switched off and you should ensure
that all knobs are set to the “”/“0” posi-
tion. Do not start cleaning until the cooker
has completely cooled.
The oven should be cleaned after every
use. When cleaning the oven the lighting
should be switched on to enable you to
see the surfaces better.
The oven chamber should only be washed
with warm water and a small amount of
washing-up liquid.
Aqualytic function
Proceed as described in the section
“Electronic programmer operation and
oven control”, pt 5.4.
When the steam cleaning process is
completed, wipe out the chamber with a
damp cloth or a sponge soaked in a mild
solution of washing-up liquid.
After cleaning wipe over chamber dry.
Use a soft, moisture absorbing cloth to
clean surfaces
Caution!
Do not use cleaning products contain-
ing abrasive materials for the cleaning
and maintenance of the glass front
panel.
1. Disconnect power from oven
2.Remove shelves and trays from the oven.
3. If the oven has telescopic shelf supports,
remove them also.
4. Use a at screwdriver to pry the lamp
cover loose, remove it, wash and carefully
wipe dry.
5. Pull the halogen bulb out by sliding it
down using a cloth or paper. If necessary,
replace the halogen bulb with a new one G9,
230V, 25W.
6. Replace the halogen bulb in its socket.
7. Replace lamp cover
Note: Make sure not to touch the halogen
directly with your ngers!
Oven lighting
To Next Page
Loading...
Need help?
General