- 46 -
INSTALL THE APPLIANCE
PLACE YOUR APPLIANCE
• When choosing the place of installation, make sure you will be able
to easily load and remove dishes and utensils from the dishwasher.
• Do not place the appliance in a room where the temperature can fall
below 0°C.
• Before installing unpack the appliance following the instructions on
the packaging.
• When you move the appliance do not handle it by the door or control
panel.
• Leave some room on all sides to have convenient access to the dish-
washer when cleaning.
• Make sure that when you set the dishwasher you do not crush the
water supply and drain hose. Also, make sure that the appliance is
not places on the power cord.
• Level the appliance using the adjustable legs. Proper level ensures
trouble-free opening and closing the dishwasher doors.
• If the dishwasher door will not close properly, check that the appli-
ance stands rmly on the oor, if not, adjust using the adjustable
legs.
Water supply connection
Make sure that domestic water supply system is suitable for the dish-
washer. It is recommended to install a lter in the water supply line to
avoid damage to the appliance due to impurities (such as sand, clay,
rust, etc.) that occasionally occur in water. This will also prevent accu-
mulation of sediment after dishwashing.
Note: When connecting to drinking water make sure that you connect
the appliance using a safety device against drinking water contamination
through backow (according to DIN EN 1717). We recommend that in-
stallation, including water supply and electrical connections, and repairs
are carried out by a qualied technician.
Water supply hose
Do not use the water supply hose from the old dishwash-
er. Use the new water supply hose provided with the ap-
pliance. Before connecting, rinse the hose with water.
Connect the water supply hose directly to the water feed
valve. The domestic water system pressure should be at
least 0.03 MPa and up to 1 MPa. If the water pressure
exceeds 1 MPa, install pressure reducing valve.
When the connection is ready, open the valve completely
and check for leaks.
For safety reasons, close the water supply tap after every
wash.
To Next Page
Loading...
Need help?
General
