- 60 -
TURN ON THE APPLIANCE
AND SELECT PROGRAMME
Turn on the appliance
1. Draw out the lower and upper basket, load the dishes and push them
back. It is commended to load the lower basket rst, then the upper
one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is
turned on to full pressure.
4. Close the door, press the Power button.
5. Choose a program, the response light will turn on. Then press the
Start/Pause button, the dishwasher will start its cycle.
Change programme
You can change the programme only if it runs for a short time. Other-
wise the detergent is already dissolved in water and the water could
be pumped out. In this case, rell the dispenser with detergent and
start the washing program from the beginning. To reset your dishwasher,
please follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press any program button for more than 3 seconds - the program will
cancel.
3. Press the desired program button to select the desired program.
4. Press the Start/Pause button, after 1 seconds, the dishwasher will
start.
Add dishes during the programme:
You can add extra dishes at any time before detergent is released. In this
case, follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Wait 5 seconds then open the door.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button after 10 seconds, the dishwasher will
start.
WARNING!
Be careful when opening the door during the dish-washing programme
as hot steam can be released and cause scalding.
To Next Page
Loading...
Need help?
General
