- 66 -
3. Larger residues can be rinsed under running water. Clean the lter
completely with a soft, clean brush.
4. Install the lters in reverse order, place the lter insert and turn
clockwise as indicated by the arrow.
WARNING: Do not overtighten the lters. Carefully replace the lters
and install in place. Otherwise, contaminants can enter the dishwasher’s
systems and cause clogging.
NEVER: use the dishwasher without the lter assembly. Incorrect lter
replacement can reduce the appliance eectiveness and cause damage
to the dishes and cutlery.
Spray arms
It is necessary to clean the spray arms regularly for hard water chemi-
cals will clog the spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
1. To remove the upper spray arm, hold the nut in the centre still and
rotate the spray arm counter-clockwise to remove it.
2. To remove the lower spray arm, pull out the spray arm upward.
3. Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
Clean the dishwasher
Frost protection
In winter, the dishwasher must be protected against freezing tempera-
ture. After each wash:
1. Disconnect the dishwasher from power.
2. Turn o the water supply and disconnect the water inlet hose from the
water valve.
3. Drain the water from the inlet hose and the water valve. (Collect the
water in a bowl)
4. Reconnect the water inlet hose to the water valve.
To Next Page
Loading...
Need help?
General
