14
OPERATION
Control panel
Upon connecting the hob to the mains a short sound should be emitted, after which you can
operate the hob.
Notice!
Do not put any objects on the areas of the sensors (fault detection can be
trigged). Always keep these areas clean.
Switching on the ceramic hob
Should you fail to activate any sensor within 10 seconds, the hob will switch o auto-
matically.
If the children lock is active, the hob cannot be switched on (see Unlocking the hob).
Switching on a hotplate
If within 10 seconds after the hob has been switched on no sensor has been activated,
the hotplate switches o.
If the hob is o, all the hotplates are switched
o and the display is blank.
When you touch the main sensor, the hob
switches on and all the hotplate indicators
show “0” for about 10 seconds. You can now
set the required heating power by touching
sensors “+” and “-“ (see Setting the heating
power).
If the hob is on (at least one hotplate is on),
then the next hotplate can be switched on by
pressing sensor (+) or (-).
You can now set the required heating power
by touching sensors “+” and “-“ (see Setting
the heating power)
To Next Page
Loading...
Need help?
General
