Amica PB 2VQ203DFT Series - OPERATION; Switching Off the Hob

16
OPERATION
If you do not start setting the heating power within 10 seconds, the point will stop
ashing by „9”, and the automatic power reduction system will stay inactive.
If you do not wish to use the automatic power reduction system, start setting
the heating power from „+” sensor.
Switching o󰀨 the whole ceramic hob
The hob is on when at least one hotplate
has been switched on. You can switch o󰀨 the
whole hob by touching the main sensor. The
hotplate indicator displays letter “H”, indicat-
ing the residual temperature.
Switching one hotplate o󰀨
You can switch o󰀨 one of the hotplates in the following way:
- touch sensors „+” and „-” at the same time or
- reduce the set point to „0” using sensor „-”
Letter “H” is displayed indicating the residual temperature.
You can now adjust the heating power at any time following the instructions provided in the
section: „Setting the heating power”.