3.7 Electronic dead man’s control (option)
In this section only the operating and safety instructions are
described which diverge from the Standard – Operating in
-
structions. Otherwise the standard operating instructions
obviously apply.
Machines with an emergency off switch can be supplied as an
option with an electronic dead man’s control. The drive is con
-
trolled over an electronic component and integrated touch sen
-
sors in the handles (sensoGRIP)(1).
3.7.1 Operation
•
Starting the motor (Section 3.5.2).
•
Pull emergency off switch (2).
•
Hold the handle (1) tightly; the machine will drive off in the set
direction of drive.
39
B8299327.ai
1
1
Danger
It is forbidden to make any changes to the system.
Deliberate or unintentional changes implemented
on the handle, the electronics or the feeder cables
can lead to a system break-down and with that en-
danger life and health.
Prior to every start-up the system must be exam-
ined for damaged cables and/or parts. Damaged
parts must be exchanged immediately. The ma-
chine may not be taken into operation with any
damaged parts.
Examine the gear switch for correct functionality
after starting up the machine by checking the
shut-down function by releasing the handle.
If, during the functionality test or machines opera
-
tions the machine does not shut-down correctly
then a continuation of operation may under no cir
-
cumstances be sustained and a visit to the
Ammann specialist workshop must take place im
-
mediately.
Despite the installation of a dead man’s control
unit a remaining danger still exists for the operator
and other persons when working with the ma
-
chine. For this reason always operate the machine
with caution and consciousness of this remaining
danger.
B8299328.ai
2
B8299326.ai
3. Operation
To Next Page
Loading...
