100 ASC 110
8. Steering cylinders
Removal from the machine
Place the machine on rm at ground. Set steering to its maximum turn and lift the cabin for easier access. Place a tray under the dis-
mounted hydraulic motor. Disconnect hoses and plug them up. Remove shims (372-11) and bolts (372-16), and press out pins (372-10)
from the ends using xture No. 3. Push the piston rod in after the piston rod pin has been pressed out. Remove the linear hydraulic
motor from the machine using hoist, sliding it out through the rear frame opening towards the drum.
To Next Page
Loading...
