160 ASC 110
16. Removal of hydraulic motors
Assembly of the linear hydraulic motor
Sliding surfaces should be lubricated – observe that the surface
of the piston rod is not damaged. New seals should be straight-
ened out. Wait at least 15 minutes before complete assembly
of the hydraulic motor after new seals have been installed. For
assembly of piston rod with the piston in the cylinder use x-
ture No. 7. Threads to be tightened with torque according to the
table.
Assembly reverse order. Replace seals.
Tightening torque
Cabin lifting hydromotor (381-3-14)
Lid connection to cylinder Piston rod, nut
Thread Tightening
torque
Thread Tightening
torque
M45x1,5
160 Nm
(118 lb ft)
M 16x1
50 Nm
(37 lb ft)
Bonnet lifting hydromotor (381-1-14) (381-2-14)
Lid connection to cylinder Piston rod 4, nut 8
Thread Tightening
torque
Thread Tightening
torque
M30x1,5
120 Nm
(89 lb ft)
M 12x1,5
40 Nm
(30 lb ft)
Note
Proper seal sets for the linear hydraulic motor may
be ordered from the equipment manufacturer indi-
cating the S/N of the equipment.
To Next Page
Loading...
