FAQ’s
Q: Why does the pedal not work?
A: Check that the power supply meets the specifications of the pedal.
Voltage (V) and polarity must match the specification exactly.
Current (mA) must be equal to or more than the specified minimum
requirement.
Ensure that the footswitch has been pressed and the power LED
is illuminated.
Ensure the instrument is connected to the pedal’s input and the
pedal’s output is connected to your amplifier.
Q: Why is my pedal making unwanted noise?
A：Check that the input and output cables are not damaged.
Check that the pedal is receiving sufficient current from the power
supply. For best results use an isolated power source for each
pedal. Daisy chaining power is a very common cause of unwanted
noise.
Avoid interference from external devices such as radios,
televisions, speakers, magnets, fluorescent lighting, etc.
Ensure the instrument is fully shielded and grounded.
Instruments with single coil electromagnetic pickups can produce
cycle 60 hum.
Q: Does this pedal work for an electric bass or acoustic guitar?
A: Effects pedals can be used for acoustic guitar (with a pickup and preamp),
electric guitar, electric bass, keyboards and synthesizers.
Q: Can this pedal be used directly into a PA system, instead of going
through an Amp?
A: This pedal can be used directly (DI) to a PA system, but it is advisable to
use a DI box or an IR loader with speaker cabinet simulation (such as the
AMMOON CAB LOADER) at the end of your signal chain.
Q: Does the LEVEL control the effect level or the signal volume?
A: Please see the pedal layout section of this manual for a description of
each parameters function.
EN
To Next Page
Loading...