When the toggle switch is on ‘D+R’, it means using Delay + Reverb Effect. It will
automatically load the Delay and Reverb setting you selected. When the Divide Led
is flashing, it means that now the knobs is controlling the Delay parameters. All the
parameters will be automatically save. Hold the footswitch for 1 second to enter Tap
Tempo mode, tap the footswitch twice to control the tempo, the Divide Led will show
‘Red’. Hold the footswitch again to quit.
ON-Reverb
Flash-Delay
Tap Tempo
Press the Divide Led, the light will always on. It means that now the knobs is
controlling the Reverb parameters. All the parameters will be automatically save.
REVERB+DELAY
EN
To Next Page
Loading...