Ampcontrol Gasguard 2 GG2 DETECTOR - Detector Wiring and Connectors

Ampcontrol Pty Ltd – ABN 28 000 915 542
GG2 DETECTOR USER MANUAL
GG2B011 Version 3 – June/19
Uncontrolled Copy - Refer to Ampcontrol Website for Latest Version
Page 23 of 39
APPROVED FOR EXTERNAL DISTRIBUTION
– PROPERTY OF AMPCONTROL PTY LTD
– NOT TO BE
REPRODUCED IN PART
NOTE
GG2 Detector is in conformance to IEC60079.0, section 7.4.2 Dielectric
strength requirement
4.6.4 Detector Wiring and Connectors
The GG2 Detector has a five-pin connector that interfaces directly to compatible modules available
from Ampcontrol or the remote cable assembly. The connector pins are detailed in Table 7.
Figure 4: GG2 Detector Connector P1 Pin numbering
Table 7: GG2 Detector connector pin out
PIN
FUNCTION
1
POWER
2
GROUND
3
DATA-
4
DATA+
5
CHASSIS
1
3
3
2
4
2