BA Series Bass Guitar Combo
8
BA Series Front and Rear Panel Features
23 24
19. HF MUTE: Press this switch in to
mute the high-frequency output.
[BA-115, BA-210]
20. FOOTSWITCH: Connect a single
or dual footswitch to this jack for
Scrambler on/off control.
[BA-112, BA-115, BA-210]
NOTE: A footswitch may be purchased
at your local Ampeg Dealer or ordered
directly from LOUD Technologies Inc.
Be sure to ask for model #AFP1, #AFP2
or #AFP3.
21. ON LED: This LED illuminates red
when the power is on.
22. POWER SWITCH: Use this switch
to turn the overall system power
on or off. Press the top of the switch
to turn on the power, and press the
bottom to turn it off.
23. POWER CONNECTOR: This is
where you connect the supplied
AC power cord.
Before plugging in the power cord,
make sure that the voltage selector
switch is set to the same voltage
as your local AC mains.
24. EXT SPKR OUT: Use this 1/4" TS
output jack to connect the amplifier
to an 8
extension speaker. The
internal speaker remains active when
an extension speaker is connected.
Use a speaker cable with 1/4" TS
ends only to make the connection.
Do not use instrument cables as
they may overheat.
[BA-210]
19 20 2221
To Next Page
Loading...
Need help?
General
